If you get an error in TradeStation stating that an indicator hasn't been verified, you can resolve this by using the Verify All command within the TradeStation Development Environment. The following video shows how this is done in TradeStation 9.5. See below for how to open the TradeStation Development Environment in TS 10.
In TradeStation 10, the method for Verifying All is the same, but getting into the TradeStation Development Environment is different. You can open it using File / New Application / EasyLanguage, as highlighted in red in the following image. Once the TradeStation Development Environment is open, use File / Verify All, as shown in the steps in the video.
Comments
0 comments
Article is closed for comments.